3D Print Checklist

From BITPlan Wiki
Revision as of 10:06, 20 February 2019 by Wf (talk | contribs) (Created page with "# Is the Filament ok ## Is it broken? ## Is there still enough of it ## Is it still dry ## Is it properly connected to the extruder via the filament detector? # Are the Filam...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
  1. Is the Filament ok
    1. Is it broken?
    2. Is there still enough of it
    3. Is it still dry
    4. Is it properly connected to the extruder via the filament detector?
  2. Are the Filament settings ok?
    1. Filament detector on?
    2. Filament diameter same as used filament?
  3. Is the printbed prepared?
    1. Is the printbed leveled?
    2. Is the printbed clean
    3. Is the printbed taped (optional)?
  4. USB connection (optional)
    1. is the connection mechanically safe - no accidential unplugging?
    2. is the connection available in during the print time (e.g. no sleep mode not planned reboots of computer)
  5. Print settings
    1. is the material / filament selected correct (see also above)
    2. is the layer height / print speed ok
    3. is Generate support enabled if necessary
    4. is Build Plate Adhesion set e.g. to Brim?
Retrieved from "https://wiki.bitplan.com/index.php?title=3D_Print_Checklist&oldid=8270"