Difference between revisions of "3D Print Checklist"
Jump to navigation
Jump to search
| Line 13: | Line 13: | ||
# USB connection (optional) | # USB connection (optional) | ||
## is the connection mechanically safe - no accidential unplugging? | ## is the connection mechanically safe - no accidential unplugging? | ||
| − | ## is the connection available | + | ## is the connection to printer going to be available during the print time (e.g. no sleep mode not planned reboots of computer)? |
# Print settings | # Print settings | ||
| − | ## is the printer selected | + | ## is the printer selected correctly? |
| − | ## is the material / filament selected correct (see also above) | + | ## is the material / filament selected correct (see also above)? |
| − | ## is the layer height / print speed ok | + | ## is the layer height / print speed ok? |
| − | ## is Generate support enabled if necessary | + | ## is Generate support enabled if necessary? |
## is Build Plate Adhesion set e.g. to Brim? | ## is Build Plate Adhesion set e.g. to Brim? | ||
[[Category:3DPrint]] | [[Category:3DPrint]] | ||
Revision as of 14:47, 20 February 2019
- Is the Filament ok?
- Is it broken?
- Is there still enough of it
- Is it still dry
- Is it properly connected to the extruder via the filament detector?
- Are the Filament settings ok?
- Filament detector on?
- Filament diameter same as used filament?
- Is the printbed prepared?
- Is the printbed leveled?
- Is the printbed clean
- Is the printbed taped (optional)?
- USB connection (optional)
- is the connection mechanically safe - no accidential unplugging?
- is the connection to printer going to be available during the print time (e.g. no sleep mode not planned reboots of computer)?
- Print settings
- is the printer selected correctly?
- is the material / filament selected correct (see also above)?
- is the layer height / print speed ok?
- is Generate support enabled if necessary?
- is Build Plate Adhesion set e.g. to Brim?