Difference between revisions of "3D Print Checklist"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| − | # Is the Filament ok | + | # Is the Filament ok? |
## Is it broken? | ## Is it broken? | ||
## Is there still enough of it | ## Is there still enough of it | ||
Revision as of 14:46, 20 February 2019
- Is the Filament ok?
- Is it broken?
- Is there still enough of it
- Is it still dry
- Is it properly connected to the extruder via the filament detector?
- Are the Filament settings ok?
- Filament detector on?
- Filament diameter same as used filament?
- Is the printbed prepared?
- Is the printbed leveled?
- Is the printbed clean
- Is the printbed taped (optional)?
- USB connection (optional)
- is the connection mechanically safe - no accidential unplugging?
- is the connection available in during the print time (e.g. no sleep mode not planned reboots of computer)
- Print settings
- is the printer selected correct
- is the material / filament selected correct (see also above)
- is the layer height / print speed ok
- is Generate support enabled if necessary
- is Build Plate Adhesion set e.g. to Brim?