Difference between revisions of "3D Print Checklist"
Jump to navigation
Jump to search
| (6 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Done|size=48}} | ||
| + | # Is the Design ok? | ||
| + | ## Did you select the desired precision? | ||
| + | ## Did you add support if necessary? | ||
| + | ## Did you select an appropriate build plate adhesion? | ||
| + | ## Did you choose the desired infill? | ||
| + | ## ... | ||
# Is the Filament ok? | # Is the Filament ok? | ||
| + | ## Is it the right diameter? | ||
| + | ## Is it the right color? | ||
## Is it broken? | ## Is it broken? | ||
## Is there still enough of it | ## Is there still enough of it | ||
| Line 13: | Line 22: | ||
# USB connection (optional) | # USB connection (optional) | ||
## is the connection mechanically safe - no accidential unplugging? | ## is the connection mechanically safe - no accidential unplugging? | ||
| − | ## is the connection available | + | ## is the connection to printer going to be available during the print time (e.g. no sleep mode not planned reboots of computer)? [https://itunes.apple.com/de/app/amphetamine/id937984704?mt=12 MacOS-Tip: Ampethamine] |
# Print settings | # Print settings | ||
| − | ## is the printer selected | + | ## is the printer selected correctly? |
| − | ## is the material / filament selected correct (see also above) | + | ## is the material / filament selected correct (see also above)? |
| − | ## is the layer height / print speed ok | + | ## is the layer height / print speed ok? |
| − | ## is Generate support enabled if necessary | + | ## is Generate support enabled if necessary? |
## is Build Plate Adhesion set e.g. to Brim? | ## is Build Plate Adhesion set e.g. to Brim? | ||
| + | = What Links Here = | ||
| + | {{WhatLinksHere}} | ||
[[Category:3DPrint]] | [[Category:3DPrint]] | ||
Latest revision as of 09:05, 23 February 2019
✓
- Is the Design ok?
- Did you select the desired precision?
- Did you add support if necessary?
- Did you select an appropriate build plate adhesion?
- Did you choose the desired infill?
- ...
- Is the Filament ok?
- Is it the right diameter?
- Is it the right color?
- Is it broken?
- Is there still enough of it
- Is it still dry
- Is it properly connected to the extruder via the filament detector?
- Are the Filament settings ok?
- Filament detector on?
- Filament diameter same as used filament?
- Is the printbed prepared?
- Is the printbed leveled?
- Is the printbed clean
- Is the printbed taped (optional)?
- USB connection (optional)
- is the connection mechanically safe - no accidential unplugging?
- is the connection to printer going to be available during the print time (e.g. no sleep mode not planned reboots of computer)? MacOS-Tip: Ampethamine
- Print settings
- is the printer selected correctly?
- is the material / filament selected correct (see also above)?
- is the layer height / print speed ok?
- is Generate support enabled if necessary?
- is Build Plate Adhesion set e.g. to Brim?