Difference between revisions of "3D Print Problems"
Jump to navigation
Jump to search
| Line 7: | Line 7: | ||
[[Category:3DPrint]] | [[Category:3DPrint]] | ||
= Undextrusion = | = Undextrusion = | ||
| + | See e.g. | ||
* https://www.raise3d.com/pages/extruding-too-little-much-plastic | * https://www.raise3d.com/pages/extruding-too-little-much-plastic | ||
* https://ultimaker.com/en/resources/21477-how-to-fix-under-extrusion | * https://ultimaker.com/en/resources/21477-how-to-fix-under-extrusion | ||
| + | in my case it happened when I set the Filament settings in the [http://marlinfw.org/docs/features/lcd_menu.html marlin menu] with | ||
| + | "E in mm3" to 1.75. This was a misunderstanding that lead the software to assume my filament was flowing faster than it was. After switching the volumentric value off things were much better. | ||
Revision as of 18:44, 18 February 2019
https://www.simplify3d.com/support/print-quality-troubleshooting/
Pillowing
- https://all3dp.com/2/3d-printing-top-layer-problems-easy-fixes-for-pillowing/
- https://rigid.ink/blogs/news/pillowing-stringing-and-splitting-what-they-are-and-how-to-stop-them
- https://www.raise3d.com/pages/holes-and-gaps-in-solid-layers
Undextrusion
See e.g.
- https://www.raise3d.com/pages/extruding-too-little-much-plastic
- https://ultimaker.com/en/resources/21477-how-to-fix-under-extrusion
in my case it happened when I set the Filament settings in the marlin menu with "E in mm3" to 1.75. This was a misunderstanding that lead the software to assume my filament was flowing faster than it was. After switching the volumentric value off things were much better.