Difference between revisions of "3D Print Bed Leveling"
Jump to navigation
Jump to search
| Line 25: | Line 25: | ||
* http://www.geeetech.com/forum/viewtopic.php?t=61959 | * http://www.geeetech.com/forum/viewtopic.php?t=61959 | ||
has a link to: | has a link to: | ||
| − | * http://www.geeetech.com/forum/download/file.php?id=4790&sid=0656df3697567a9e78429622e3a5f998 | + | * [http://www.geeetech.com/forum/download/file.php?id=4790&sid=0656df3697567a9e78429622e3a5f998 Marlin-1.1.9_A10_with bltouch.zip] |
| + | that i used as a Basis. | ||
| + | <source lang='c' highlight='6'> | ||
| + | /** | ||
| + | * The BLTouch probe uses a Hall effect sensor and emulates a servo. | ||
| + | */ | ||
| + | #define BLTOUCH | ||
| + | #if ENABLED(BLTOUCH) | ||
| + | #define BLTOUCH_DELAY 375 // (ms) Enable and increase if needed | ||
| + | #endif | ||
| + | </source> | ||
== Installation == | == Installation == | ||
Revision as of 10:35, 17 January 2020
Test print
Testing with a bigger knob on the A10
3D Touch Sensor
Geeetech Sensor
see facebook post
The following Sensor works on a Geeetech A10:
https://www.amazon.de/gp/product/B07M5JHKYP
BLTouch
I had the Geeetech Sensor in operation for a while but it did not work as satisfactory as hoped. I am trying the "original" BL Touch now see http://www.BLTouch.com
Firmware 1.1.9 with BLTouch
has a link to:
that i used as a Basis.
/**
* The BLTouch probe uses a Hall effect sensor and emulates a servo.
*/
#define BLTOUCH
#if ENABLED(BLTOUCH)
#define BLTOUCH_DELAY 375 // (ms) Enable and increase if needed
#endif
Installation
I had to follow both of the following videos to get the Sensor working:
The firmare is available from
- Geeetech's github site
- https://github.com/jakobend/Marlin-A10
- https://drucktipps3d.de/forum/topic/mein-geeetech-a10-neue-revesion-und-ich/?part=2
see videos and Marlin on how to compile and flash the firmware onto the device.
Level Mesh visualization
The following visualization was created with the Bed Visualizer plugin of OctoPrint
