Difference between revisions of "Broom Handle Extension DIY"
Jump to navigation
Jump to search
(→Steps) |
(→Steps) |
||
| Line 13: | Line 13: | ||
# Cut the shrink tube to fit [[File:SAM_0723.JPG|400px]] | # Cut the shrink tube to fit [[File:SAM_0723.JPG|400px]] | ||
# Pull the shrink tube over perforated steel tape and heat with a lighter to shrink it | # Pull the shrink tube over perforated steel tape and heat with a lighter to shrink it | ||
| − | # Bend the steel tape and connect ends with the Allen Screw using the Wing Nut and the Allen Key | + | # Bend the steel tape and connect ends with the Allen Screw using the Wing Nut and the Allen Key [[File:SAM_0727.JPG|400px]] |
| − | [[File:SAM_0727.JPG|400px]] | ||
# Create a connection between the two handles at two points where you tie together the parts with the perforated steel tape [[File:SAM_0729.JPG|400px]] | # Create a connection between the two handles at two points where you tie together the parts with the perforated steel tape [[File:SAM_0729.JPG|400px]] | ||
Revision as of 07:13, 23 February 2021
Problem
You need to connect to broom handles. For example a telescope and a regular one to extend from 4.5 m to some 6m.
Parts List
- 2 x Perforated Steel tape 150mm x 17 mm (8 holes > 6mm)
- 2 x Allen Screw 6 x 40 mm
- 2 x Wingnut 6 mm
- 2 x Shrink Tubing 20 mm x 140 mm
- 1 x Allen Key 4 mm
Steps
- Cut the shrink tube to fit
- Pull the shrink tube over perforated steel tape and heat with a lighter to shrink it
- Bend the steel tape and connect ends with the Allen Screw using the Wing Nut and the Allen Key
- Create a connection between the two handles at two points where you tie together the parts with the perforated steel tape
